日本xxxx裸体xxxx,久久综合给合久久狠狠狠9,日韩中文字幕免费视频,老熟女大屁股熟妇

 Standard

1. Rotating electrical machines - Rating and performance.(GB755-2008)
2. Impulse voltage withstand levels of form-wound stator coils for rotating a.c. Machines.(GB/T22715-2008)
3. Test specifications of interturn insulation of armature winding for DC electrical machines.(GBT22716-2008)
4. Test specifications of interturn insulation of field pole coil and field winding for electrical machines.(GBT22717-2008)
5. Electrical insulation system -Electrical stresses produced by repetitive impulses - Part 1: General method of evaluation of electrical endurance.(GBT22566.1-2008)

 Can check out the fault

Turn-to-turn fault

Corona discharge

Disconnection of the winding

Number of turns differences

 security

1. High voltage circuit has to start, stop buttons and dual foot switch insurance circuit, the safety and reliability of the instrument operation is higher.
2. High voltage output circuit with high voltage display digital table, can display high-voltage equipment at work, In the digital table shows changes to "0", reminding the operator to swap the motor (coil), Avoid high-pressure switch motor(coil), increase the safety of use. At the same time with a warning  when  the instrument is working, light serve as a warning.
3. Output high voltage wires with 30 kv line of silicone pressure. Fixture with large size, and good elastic clamp,Make better contact with the motor and fixtures.

 Reliability

Thyratron, filament, and trigger of the transformer with low voltage work mode, greatly reduces the voltage of high voltage auxiliary power supply circuit and operating voltage of trigger transformer, improves the safety and reliability.

Using high voltage loop isolated high frequency current sensor, and directly display through the thyratron and winding current waveform, to prevent the damage caused by a thyratron overload, at the same time, reduce the interference on the oscilloscope.

 Main technical parameters

1. Supply voltage: 220V±5%, 50Hz±2%
2. The peak voltage of impulse wave :  0.3～6KvP
3. Frequency of impulse wave :0.1μF（Can choose according to the requirements Maximum output power: 1.8J
4. Scope of application: AC/DC motor below 1140V